So this toilet shaft part seems to be the wrong size once it gets here … is there any place that might actually have this in stock???
https://www.facebook.com/70684391248/posts/10155981254571249
Source
Posted by: Cindy Chebultz
Tonight’s project:. We have air, but no noise?? Kiddo says the screws are stripped, or corroded, or too tapered, or something??? Who has gotten their original air horn working again?
https://www.facebook.com/70684391248/posts/10155978065781249
Source
Posted by: Cindy Chebultz
This is the dirty water hose that is attached on the back of my 52 year-old Grocob… The hose itself is leaking a bit within that connector piece, what’s the best way to seal that off and stop the leak??
https://www.facebook.com/groups/70684391248/permalink/10156060694971249
Source
Posted by: Cindy Chebultz
URL:
https://www.facebook.com/70684391248/posts/10156060694971249
Today’s Project: the mothership’s tender… Kiddo has been working on it since b… – Life of a Captain
Today’s Project: the mothership’s tender… Kiddo has been working on it since before winter and now it’s ready to start going back together. Progress pics here https://lifeofacaptain.com/tag/rocket/… It’s a 1956 Feathercraft Rocket with a 1956 Mercury Mark 30 motor Today's Project: the mo…
Today’s Project: the mothership’s tender… Kiddo has been working on it since before winter and now it’s ready to start going back together. Progress pics here https://
https://www.facebook.com/70684391248/posts/10155959589216249
Source
Posted by: Cindy Chebultz
Tonight’s project: memory foam mattress toppers for the kiddo’s beds. Albert we found another purpose for our Japanese pull saw (worked like a charm)
https://www.facebook.com/70684391248/posts/10155955529221249
Source
Posted by: Cindy Chebultz
So before I got this boat it was barely used for 10+ years. And I always just use the onboard water tank (because you can’t sink a boat with water that’s on board) but the stuff in the bottom of the water tank occasionally clogs up my faucets and shower. Next time it gets low maybe I need to see if there’s a way to Shop-Vac it out??? Any other suggestions??
https://www.facebook.com/70684391248/posts/10156036136986249
Source
Posted by: Cindy Chebultz
Compressor upgrade. Had to finally ditch the original 120 v beast that weights about 70 lbs. Installed new 12 volt in the galley pantry. She charges to 150 psi and I intigrated the original holding tank which is about 20 gallons on the engine room ceiling. This project also freed up necessary engine room space and will be good for deisel conversion later this coming winter. Its too quiet here now to do a test video but i will follow up with that. My trumpets are louder than ever. They never seen more than 90ish psi.
— at Burnham Harbor.
https://www.facebook.com/70684391248/posts/10156025557921249
Source
Posted by: Albert Bartkus
Tune up today. This is why we know a repower is inevitable. I suspect there will be a bit more nursing this season and keeping a close eye on my mains and genset for that matter. Genset is up to 3,652 hours and actually still going strong.
https://www.facebook.com/70684391248/posts/10155963297021249
Source
Posted by: Albert Bartkus
Tonight’s project: Central Vacuum. Anyone that has a ’45ish boat … This port side cabinet in the the salon holds a Dirt Devil central vac system perfectly (I just slide it over, tip it forward and change the bag) … This is the same system that Albert installed on Marianne
https://www.facebook.com/70684391248/posts/10155953665296249
Source
Posted by: Cindy Chebultz